SERVICE Sp problem Trouble Sc Error +RESET problem hp plotters 500, 450, T610 hp Dj 1050c check printhead path (1) (2) help +
|
||||||||||||||||||||||
clean..... επισκευή Ελέγξτε τη διαδρομή της κεφαλής εκτύπωσης ....... ......... hp Dj 1050c clutch feed C6072-60151 ............. 2015-03-24 BELT was damadged, so I replace with new one... after power on ...gives the error .. Ph carriage moves a little L- R -L and stops sensor lights Red on enconder strip .... or check strip enconder position out off ps path.... This warning appears whenever friction on the Scan-Axis is too high: the electrical current needed by the Scan-Axis Motor to move the Carriage is too high, so before burning the motor or the Main PCA, this warning appears. 2016-06-18 ............... system error 0b0006 System Error: 0B0006 Problem Description: The Trailing Cable has been incorrectly connected OR the fuse in the Electronics Module has been burned. Corrective Action: WARNING Turn the Printer OFF and disconnect the trailing cable. Check that the ends of the Trailing Cable are flat and are not damaged or bent. Reconnect the Trailing Cable correctly, making sure it is pushed in firmly (Refer to the instructions on Page 8-39). Power ON Printer and check if the Error Code disappears. If the Error Code continues, replace the Electronics Module (Refer to the instructions on Page 8-25)making sure you take care when you reconnect the trailing cable. PLEASE TAKE CARE WHEN CONNECTING THE TRAILING CABLE TO THE ELECTRONICS MODULE. INCORRECT INSTALLATION WILL BURN THE FUSE IN THE ELECTRONICS MODULE, CAUSING THE COMPLETE REPLACEMENT OF THE ELECTRONICS MODULE. ...... 003402:000001 carriage moves 5cm to right + 1 cm to left and gives error by: fuse F7? cables, main PCA.... 2016-07-27 ………… Removal and Installation 8-27 HP DesignJets 1050C and 1055CM Printers Service Manual Installation of the Electronics Module WARNING When reconnecting the Trailing Cable to the Electronics Module, make sure you connect it correctly as follows: 1. Start reconnecting the Trailing Cable from left to right (the longest strip will be connected to the 1st clip from the right). 2. Make sure you push the Trailing Cable in straight and not bent. Once the Trailing Cable is inserted, you should hear an audible click. 3. When the Trailing Cable is inserted correctly, the shaded part (as shown below) will not be visible. 4. Before powering ON the Printer, check the continuity (using a tester) between the two points (as shown below). n If there is continuity between the two points, then the Trailing Cable is installed incorrectly. Do NOT power ON the Printer because you will burn an internal Electronics Module fuse. Disconnect the Trailing Cable and reconnect again using the above steps. n If there is no continuity between the two points, then it is possible to power ON the Printer without burning the internal Electronics Module fuse, but there is a possibility that you may still get the System Error Code 0B0006, in which case you have to reconnect the Trailing Cable using the above steps. Check Continuity between these 2 point ......... Part description Models - C6090A/V, C6091A/V Models - C6095A/V, C6096A/V ......... 2016-06-18
|
Last Updated: