KM3035 reset C-6000, 6200 6050(with fax) 4000, 4100, 3200
πως να σβησετε το λαθος ...(error code)
enter Maintenace Mode..press...1087 1087 ...displays.U000
select sp163 Start, EXECUTE, OK, Start, .... selection completed.....
...........
KM5035 ===c6000 overheat (fuser fuse cut...)
KM3530 ===c6000 fuser Main Lamp not turns on ===CB defective
........
Kyocera ΚΜ 3530 polygon scanner motor used
Polygon motor steady-state problem
• The polygon motor rotation is not stable
for 600 ms after the polygon motor
rotation has been stabilized.
Poor contact in
the polygon motor
connector terminals.
Defective polygon
motor.
Defective power
source PCB.
Defective main
PCB.
Reinsert the connector. Also check for continuity
within the connector cable. If none,
remedy or replace the cable.
Replace the LSU (see page 1-6-20).
Check if 24 V DC is supplied to CN2-1 on
the main PCB. If not, replace the power
source PCB.
Check if 24 V DC is output from CN8-10 on
the main PCB. If not, replace the main
PCB.
C6000
Broken fixing heater wire
• The fixing temperature does not increase
for 40 s after the fixing heaters
have been turned on for warming up.
• The fixing temperature remains below
50 °C/122 °F for 10 s continuously
after the fixing heaters have been
turned on during stabilization.
C6020
Abnormally high fixing unit thermistor
temperature
• The fixing temperature exceeds 230
°C/446 °F for 10 s. 2015-03-09
2012-11-20
c6000 KM5035=======fuser Overheat ...
fuse open! +uhr scratched by fuse
2015-11-03